WIRELESS KNOWLEDGE

MIPRO's Proprietary "ACT" Function & Operation

What is ACT

"ACT" stands for "Automatic Channel Targeting" and is a world first technology from MIPRO. "ACT" allows you to automatically transfer the frequency selected for your receiver, to your PLL transmitters.

ACT Features

No manually adjusting needed like traditional transmitters. Simple, fast and precise frequency set without mechanical error. Once the frequency has been set, the data is stored in memory, meaning that the frequency is set until it is changed by performing the "ACT" function again, even after powering off.

ACT Set-Up

• Press the "ACT" button on the receiver panel.

• The channel indicator and frequency on the VFD display will then start to flash, indicating ACT function is activated.

• Locate and point the "ACT" mark or pot on the transmitter towards the "ACT" button on the receiver and hold the transmitter within 30cm of the receiver.

• When the channel indicator & frequency stop flashing, the RF signal indicators lit. This indicate the same frequency of both transmitter and receiver are synchronized.

• To cancel ACT function, simply press the "ACT" button again and the channel indicator and frequency will stop flashing.